Are you planning a coating flooring project and would want to go solo on your own in the typical DIY defiance? Traditionally, the optimal way to get a well-done elegant and long-lasting epoxy floor is to engage an expert to deliver the right job. Yet, this doesn’t forbid you from trying these things on your own and learning something new. What more? It is always fun to be in charge!
The good news is utilizing epoxy floor coating can be done by just anyone so long you keep to precautions. Epoxy floor coating is very popular with many homeowners because of its durability and being straightforward to maintain. Also, when applied correctly, it gives you a fantastic look and crisp touch.
If this is your first time in handling your flooring projects, then you can be subject to some frequent mistakes that can damage the entire resin, thereby giving you negative results. Below are three common pitfalls you must avoid for you to get a better and fulfilling outcome.
Make Sure to Choose the Right Epoxy Resin
The first step is to have the appropriate epoxy resin for the flooring project you had in mind. Actually, epoxy is the most preferred flooring material among homeowners.
It is crucial you carry out detailed research to ascertain the particular type of designs that fits into your project needs. Whether it is a normal floor coating or your regular basement floor coating, a thorough investigation will assist you in choosing the correct epoxy products.
Measure and Mix Your Epoxy Resin Correctly
One of the most pitiable mistakes beginners commit is not knowing the right volume of hardener and resin required to implement an evenly epoxy spread on the floor surface. Such consequential ignorance is widespread when dealing with garage floor coating.
It is imperative that you start small and then come back to the measurement cycle again. Always use a graduated measuring cup to get the adequate measurement of your epoxy resin, this leaves out any form for error.
To have a beautiful cure of your resin, the bottom of the liquid surface (also known as meniscus) should meet the line where you pour the resin.
When you get the well-measured resin ready, you can pour the required amount of hardener into the solution. Many epoxy systems are formulated into a 2:1 ratio—which involves two components of resin to a portion of hardener.
Mixing of the epoxy comes with its difficulties for a beginner. The most common of these challenges is when the epoxy is mixed too fast using a paddle mixer. This often leads to air being trapped in the epoxy. You can avoid this by mixing your epoxy at a relatively reduced pace
Inadequate Surface Preparation
If you want to have a skirt epoxy floor failures or poor finishes when engaging in a garage floor coating or any other type of coating, you must take prepping of the concrete surface seriously. It takes more than a clean surface, but also a floor surface that is free from oil or any contaminants.
The surface must be thoroughly cleaned and dried, and any junk left can infiltrate your epoxy coating. This can cause a crack over-time. Following the tips mentioned above can help you mitigate any of these avoidable mistakes and actualize your desired results.
Are you on the lookout for the highest quality resins like epoxy primers and epoxies, for that spectacular seamless flooring. Walttools has all your home has been screaming for. Here is one secret you should know: if it is not of the highest grade, it is not from Walttools!